The drone jammer device can automatically drive away the aerial photography drones in the 1.5G/2.4G/5.8G frequency band within a radius of one kilometer, and prohibit the illegal entry of aerial photography drones in areas that need to be shielded, or take pictures for automatic shielding (And in a black screen) So what are the issues that need to be paid attention to when installing drone anti jammer?
1. Install the fixed station drone first select the installation location, select the high location of the area to be covered for installation on the top, or perform all-round coverage on the high location directly opposite.
2. When installing the drone signal jammer of the fixed station, you must use a wrench to tighten the antenna or the connector at the link. If the antenna is not installed, it is forbidden to turn on the device, which will burn the host module.
3. When installing drones in fixed stations outdoors, attention should be paid to outdoor waterproofing. It is forbidden to install them in places where water is likely to accumulate, or install the drones horizontally, which may cause water to burn out the main unit.
4. After the fixed station UAV shield is installed, adjust the launch angle of the antenna according to the needs of the site, power on and use the mobile phone to test whether the signal completely covers the shielding area.
The above is a brief introduction of Jammer mart for the installation of drone gun jammer. If you want to know more about jammers, please search Jammer mart and go to the website to see more about jammers.
